following steps:
z As shown in the picture on the right, take off two covers from the front frame and then
unfasten two fixture screws.
z Pull the front frame towards yourself and take it off.
To put the front frame back, reverse the steps.
You should check whether the front frame is firmly fixed into the fixture groove on the top.
2. Check the water discharge
z Pour a cup of water into groove.
z Check whether the water flow through the water discharge hole.
Pipe Connection
z Connect the pipe to the unit: point to the center of
pipe and fasten the connection screw at first by
hand and then by wrench until it is tightly
fastened. The fastening direction is shown in
the picture.
z Pointing towards the center of pipe, fasten the screw
with strength.
z Wrench the screw in the end until you hear the
“click” sound.
The fixing of pipe
z Wrap up all pipe, water discharge and
connection wire from top to below.
z Cover the connection parts with
insulation material and fix them with two
plastic rings.
z Wrap up the pipes with tape alongside the wall
and fix them to the wall with clips. These
To Next Page
Loading...
