AVAPressure washer P60/P70 / P80
8 |
constant flow of water to clear the air
from the machine and water supply
hose. Release trigger. Press the safety
lock (front button on the gun handle).
Turn button on main switch. Point the
power gun downwards. Press the trig-
ger safety lock to release the trigger.
Fully press the trigger.
Auto-stop function
The machine is designed to switch off
the motor when the trigger is released
on the gun.
Working Advice
General
Ensure that the pressure washer is on
level ground.
Do not overreach with the high
pressure hose or move the pressure
washer by pulling the hose, this could
cause the machine to become unsta-
ble and fall over.
Do not kink or drive a motor vehicle
over the high pressure hose. Do not
expose the high pressure hose to
sharp edges or corners.
î Never use a roto nozzle or pencil
jet to clean motor vehicles.
WARNING!
The Patio Cleaners sup-
plied are only intended to be used on
flat surfaces! Do not attempt to use
them on steps.
Never attempt to touch the rotating
nozzle while operating the machine!
Working advice for cleaning with deter-
gents
For products
not sold in GB:
WARNING:
For your safety, it is re-
quired that the plug attached to the
machine is connected with the exten-
sion cord. The coupling of the exten-
sion cord must be protected against
splash water, be made of rubber or
coated with rubber. The extension
cord must be used with a cable strain
relief. To prevent damage to the appli-
ance, do not allow it to operate dry.
Products sold in GB only:
Your product
is fitted with an BS 1363/A approved
electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your
socket outlets, it should be cut off and
an appropriate plug fitted in its place
by an authorized customer service
agent. The replacement plug should
have the same fuse rating as the
original plug.
The severed plug must be disposed of
to avoid a possible shock hazard and
should never be inserted into a mains
socket elsewhere.
Operation
Starting
Attach water supply hose (not sup-
plied) to the mains water supply and
machine.
Connect the product to the mains
supply ensuring that the mains switch
is in the off position.
Open water tap.
Press the safety lock (back button on
the gun handle) to release the trigger.
Fully press the trigger until there is a
English
To Next Page
Loading...
