AVA Pressure washer P60/P70 / P80
| 9
– Universal coupling to the pressure
washer
This enables the pressure washer to
draw water up to 0.5 m above the
water level in the source in approxi-
mately 15 seconds.
Submerge the 3 m hose in water to
displace the air. Connect the 3m sup-
ply hose to the pressure washer en-
suring that the inlet strainer remains
submerged in the water source.
Run the pressure washer with the gun
disconnected until a steady flow of
water appears from the high pressure
hose. Stop if this has this has not
been achieved within 25 seconds and
check all the connections. Switch off
and connect the gun, lance and nozzle
to operate.
It is important to ensure that all hose
and coupling connections are of good
quality, air tight and that all washers
are in good condition and correctly
seated in place. Failure to do so may
affect the self priming performance.
Water Tanks with outlet connections
When connecting the pressure wash-
er to a water tank with a suitable tap
outlet, first connect the supply hose
(not provided) to the tank outlet, open
the tap to allow the water to displace
all the air in the hose and then con-
nect to the pressure washer.
Maintenance and Service
Maintenance
Stop, remove plug from the power
supply and disconnect from water
supply.
Only use cleaning agents suit-
able specifically for high pressure
washers.
We recommend that you use deter-
gent sparingly for the sake of the en-
vironment. Observe the recommended
dilution on the detergent label.
The high-pressure foam nozzle
supplied with this product includes
a regulator to control detergent use.
Adjust as required.
Recommended cleaning method
Step 1:
Attach the fixed fan nozzle and
remove the heavy dirt.
Step 2:
Attach the foam bottle and
spray on the detergent sparingly.
Step 3:
Rinse off the loosened dirt and
detergent with the fan nozzle.
Note:
When cleaning a vertical sur-
face spray off dirt/detergent from
the bottom and work in an upwards
direction. Rinse from the top and work
downwards.
Use with alternative water sources
This high-pressure washer will self
prime and can draw water from water
tanks and natural water sources. It’s
IMPORTANT
that the water is clean
and the AVA inlet filter is clear and
fitted to the machine.
Open tanks/containers and natural water
sources
Use the Self Priming accessory kit
comprising:
– Inlet strainer with non return valve
– 3m reinforced supply hose
English
To Next Page
Loading...
