Avalla K-45 - First Time Set up

05En
First time set up: K-45
Remove all packaging. Remove the 'Cooker lid' by turning it
clockwise and take out the spatula and 'Condensation cup' from
the 'Cooking pot'.
Remove the 'Heat shield' from the underside of the 'Cooker lid' by
pullingthe'Siliconegrabpoint'rmly.Thenremovethe'Silicone
ring' from the 'Heat shield'.
Clean the 'Cooker lid', 'Cooking pot', 'Silicone ring' and 'Heat shield'
in warm soapy water and then dry thoroughly.
Replace the 'Silicone ring' around the 'Heat shield', ensuring it is
seated correctly. It can be placed either way. If the 'Silicone ring' is
not properly seated the lid won't seal fully and the cooker won't be
able to pressurise.
Re-attach the 'Heat shield' to the 'Cooker lid', ensuring it is
connectedrmly.
Replace the 'Cooker lid', turn it anti-clockwise until it locks in place.
Makesureit’scorrectlytted.
Position the 'Condensation cup' in the allocated slot at the back of
the unit.
Set the 'Pressure release valve' to 'Seal' or 'Vent' according to your
recipe’s instructions. See image below.
Vent
Seal
05 04