Avalla K-45 - First Time Set up

09En
Remove all packaging. Remove the 'Cooker lid' by turning it
clockwise and take out spatula from the 'Cooking pot'.
Remove the 'Heat shield' from the underside of the 'Cooker lid' by
pullingthe'Siliconegrabpoint'rmly.Thenremovethe'Silicone
ring' from the 'Heat shield'.
Clean the 'Cooker lid', 'Cooking pot', 'Silicone ring' and 'Heat shield'
in warm soapy water and then dry thoroughly.
Replace the 'Silicone ring' around the 'Heat shield', ensuring it is
seated correctly around the 'Heat shield'. It can be placed either
way. If the 'Silicone ring' is not properly seated the lid won't seal fully
and the cooker won't be able to pressurise.
Re-attach the 'Heat shield' to the 'Cooker lid', ensuring it is
connectedrmly.
Replace the 'Cooker lid', turn it anti-clockwise until it locks in place.
Makesureit’scorrectlytted.
Set the 'Pressure release valve' to 'Seal' or 'Vent' according to your
recipe’s instructions. The K-90 features a 360 valve system which
allows the 'Pressure release valve' to 'Seal' or 'Vent' in 3 positions.
The valve is set to 'Seal' in a dropped position and 'Vent' in a raised
position. The image below is a guide.
First time set up: K-90
Vent
Seal
SealSeal
Vent Vent