www.avantgarde-acoustic.de page 5
Version 1.4 – May 25, 2007
SOLO
OPERATING INSTRUCTIONS
SPEAKER ASSEMBLY
GRAPHIC 3
INSTALLATION OF SPEAKER STAND
1. Please refer to the instructions in graphic 3 to
assemble the speaker stand.
2. Place the SOLO on top of the bolt (big front
tube of the speaker stand) and let the speaker
carefully slide down till it fully rests on the
speaker stand.
3. Please note that the speaker will sit very tight.
Some pressure might be required for sliding
the speaker down to the bolt.
Tips and tricks to determine the optimal
position of the speakers can be found in the
respective chapter of this manual.
To Next Page
Loading...
