www.avantgarde-acoustic.de page 4
Version 1.4 – May 25, 2007
SOLO
OPERATING INSTRUCTIONS
SPEAKER ASSEMBLY
140 mm
137 mm
348 mm
140 mm
210 mm
250 mm
137 mm
348 mm
120 mm
35
25
140 mm
23
250 mm
HOLE
Ø 10 mm
HOLE
Ø 8 mm
75 mm
GRAPHIC 1
GRAPHIC 2
UNPACKING THE SPEAKER SYSTEM
1. IMPORTANT
Please keep in mind that the SOLO is very
heavy and has a weight of 65 lbs (30 kg).
Get some help to unpack the speaker
carefully.
2. Completely open the packing box at the top.
Carefully tip over the box upside down, so the
base of the box should be facing up.
3. Now you can easily lift the box up and remove
the packing inserts which protect the system.
4. Remove the plastic sack.
5. IMPORTANT
Before lifting the speaker, make sure that the
ground is covered with a soft blanket, so the
speaker does not get scratched or damaged.
GENERAL
For optimal placement of the speaker Avantgarde
Acoustic offers as an option a stable wall mount
bracket or alternatively a beautiful speaker stand.
Please keep in mind that the SOLO is very heavy
and has a weight of approx. 65 lbs (30 kg).
Get some help when lifting the speaker!
INSTALLATION OF WALL MOUNT BTRACKET
(See graphic 1)
1. IMPORTANT
Make sure that the wall is strong enough to
hold the full weight of the speaker (65 lbs /30
kg). Always use all 4 screws to install the wall
mount . The minimum size of the screws
should be M8 x 60 mm. Use the appropriate
dowels depending on the structure/material of
your wall.
2. Pre-position the wall mounts vertically and
horizontally before sliding the speaker onto
the bolt .
3. To position the speaker system, the wall
mount can be twisted and angled. To adjust
the horizontal direction untightening screw
, twist the wall mount bracket and than re-
tighten the screw .
4. Untighten the screws and with the
appropriate tools and adjust the inclination of
the wall mount. Tighten the screws and
firmly before sliding the speaker on top.
If it is required to readjust the position, always
remove the speaker before!
To Next Page
Loading...
