Avaya 4500 - Page 15

Private VLAN Edge Technical Configuration Guide
15
July 2010
avaya.com
o Add data VLAN 1100 with port members 2, 3, and 6 for Client 2’s traffic to both VMware
Server 1 and VMware Server 2
o Add data VLAN 1200 with port members 2, 3, and 4 to allow traffic between the VMware
backup server and VMware Server 1 and VMware Server 2
o Add a policy with an Interface action extension to force all traffic from VLAN 1200 from
ports 2 and 3 to be forwarded to port 4
o Ports 5 and 6 are untagged while ports 2, 3, and 4 are tagged
2.2.1 Configuration – ERS5520-1
2.2.1.1 Go to configuration mode.
ERS5520-1 Step 1 - Enter configuration mode
5520-24T-PWR> enable
5520-24T-PWR# cmd cli
5520-24T-PWR# configure terminal
5520-24T-PWR(config)# banner disable
5520-24T-PWR(config)# snmp-server name ERS5520-1
2.2.1.2 Create VLAN
ERS5520-1 Step 1 – Change the VLAN configuration control mode from default setting of strict to
automatic; this will automatically add the PVID to the VLAN port member
ERS5520-1(config)# vlan configcontrol automatic
ERS5520-1 Step 2 – Create VLANs 1000, 1100, and 1200
ERS5520-1(config)# vlan create 1000 name Client1 type port
ERS5520-1(config)# vlan create 1100 name Client2 type port
ERS5520-1(config)# vlan create 1200 name Backup type port
ERS5520-1 Step 3 – Enable VLAN tagging on ports 2, 3, and 4
ERS5520-1(config)# vlan ports 2-4 tagging tagall
ERS5520-1 Step 4 – Add port members
ERS5520-1(config)# vlan members add 1000 2-3,5
ERS5520-1(config)# vlan members add 1100 2-3,6
ERS5520-1(config)# vlan members add 1200 2-4
ERS5520-1 Step 5 – Remove port members from default VLAN
ERS5520-1(config)# vlan members remove 1 2-6