Private VLAN Edge Technical Configuration Guide
4550T-1 Step 3 – Configure a Layer-2 classifier and classifier element to select all ingress traffic
4550T-1(config)# qos l2-element 1
4550T-1(config)# qos classifier 1 set-id 1 name all_traffic element-type l2 element-id
1
4550T-1 Step 4 – Add a policy and apply the QoS action to the interface group configured above
for all the access port members
4550T-1(config)# qos policy 1 name fwd_port_27 if-group pri_vlan clfr-type classifier
clfr-id 1 in-profile-action 10 precedence 6
Please note the ERS4500 series support up to 7 policy precedence levels. By default, you can
only select a precedence level as high as 6 unless DHCP Relay is globally disabled. Hence, if
you will never use DHCP Relay, you can disable DHCP Relay globally using the CLI command
no ip dhcp-relay which in turn will allow you to use precedence level 7.
Use the CLI command show qos diag to view the total filter resources used and available.
To Next Page
Loading...
