• Assigning a static IP address to the Mediation Server module using Windows on
page 29
• Assigning a static IP address to the Mediation Server module using a console
connection on page
27
•
Configuring a description for the midplane interface on page
29
•
Displaying the midplane interface configuration on page 30
• Configuring the Mediation Server on page
30
Specifying an IP address for the midplane interface
Use this procedure to specify an IP address for one of the midplane Ethernet interfaces that
connects to the Mediation Server module.
By default, no IP address is assigned to the interface.
Procedure steps
1.
To enter configuration mode, enter:
configure terminal
2. To select midplane interface configuration, enter:
interface servmod <slot/port>
3. To specify an IP address for the midplane interface, enter:
ip address <ip-address> <subnet-mask>
4. To enable the interface, enter:
no shutdown
Enabling DHCP on the midplane interface
Use this procedure to enable DHCP on the midplane Ethernet interface.
To
enable the Mediation Server module functionality, you must configure an IP address on one
of the Mediation Server interfaces. If you are configuring the Mediation Server remotely, you
can enable the DHCP server on one of the connected SR4134 midplane Ethernet interfaces
to assign an IP address to the Mediation Server module.
Procedure steps
1. To enter configuration mode, enter:
Mediation Server module configuration for SR4134
26 Avaya AG2330/SR2330/SR4134 Quick Start Guide August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
