Avaya G250 - Administration Manual

720 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

Administration for the Avaya G250

and Avaya G350 Media Gateways

03-300436

Issue 3

February 2007

Table of Contents

Default Chapter3
- Table of Contents3
About this Book21
- Overview21
- Audience21
- Downloading this Book and Updates from the Web21
  - Downloading this Book21
- Related Resources22
- Technical Assistance23
  - Within the US23
  - International23
- Trademarks23
- Sending Us Comments24
Chapter 1: Introduction25
- G250 and G350 Contents25
- G250 and G350 Support Information26
- G250 Available Models27
Chapter 2: Configuration Overview29
- Defining the Console Interface29
- Defining the USB Interface30
- Defining Other Interfaces30
- Configuration Using CLI31
- Configuration Using GUI Applications31
- Saving Configuration Changes32
- Firmware Version Control32
Chapter 3: Accessing the Avaya G250/G350 Media Gateway35
- Accessing the CLI35
- Accessing the CLI Via Modem37
- Accessing Avaya IW40
  - Access and Run the Avaya IW Using a Laptop Computer40
- Accessing GIW41
  - Access the GIW42
- Accessing PIM43
- Accessing Avaya Communication Manager43
- Managing Login Permissions44
- Special Security Features57
Chapter 4: Basic Device Configuration69
- Defining an Interface69
- Configuring the Primary Management Interface (PMI)70
  - Setting the PMI of the G250/G35070
- Defining the Default Gateway71
- Configuring the Media Gateway Controller (MGC)71
- DNS Resolver77
- Viewing the Status of the Device83
- Software and Firmware Management84
Chapter 5: Configuring Standard Local Survivability (SLS)99
- SLS Service99
- Avaya Phones Supported in SLS100
- Call Processing in SLS Mode101
- Call Processing Not Supported by SLS102
- Provisioning Data103
- PIM Configuration Data104
- Entering SLS Mode104
- Configuring SLS115
Chapter 6: Configuring Ethernet Ports175
- Ethernet Ports on the G250175
- Ethernet Ports on the G350176
- Configuring Switch Ethernet Ports177
  - Switch Ethernet Port Commands177
- Configuring the WAN Ethernet Port178
- Configuring DHCP Client180
- Configuring LLDP184
  - Supported Tlvs185
  - LLDP Configuration186
    - Supported Ports for LLDP186
Chapter 7: Configuring Logging187
- Configuring a Syslog Server188
- Configuring a Log File191
- Configuring a Session Log193
- Configuring Logging Filters195
Chapter 8: Configuring Voip Qos201
- Configuring RTP and RTCP201
- Configuring Header Compression201
- Configuring Qos Parameters206
  - Configuring RTCP Qos Parameters207
- RSVP Parameters207
- Weighted Fair Voip Queuing (WFVQ)207
  - Configuring Weighted Fair Voip Queueing (WFVQ)208
Chapter 9: Configuring the G250 and G350 for Modem Use209
- Configuring the USB Interface209
- Configuring the USB Port for Modem Use209
- Configuring the Console Port for Modem Use211
  - Configuring the Console Device212
Chapter 10: Configuring WAN Interfaces213
- Serial Interface Overview214
- Initial WAN Configuration216
- Backup Interfaces232
- Modem Dial Backup233
- ICMP Keepalive252
- Dynamic CAC255
  - Enabling Dynamic CAC and Setting Maximum Bandwidth255
  - Displaying Bandwidth Information256
- Object Tracking256
- Frame Relay Encapsulation Features271
  - Frame Relay Traffic Shaping and FRF.12 Fragmentation272
- Priority DLCI272
  - PPP Voip Configuration273
Chapter 11: Configuring Poe279
- Load Detection279
- Poe Configuration CLI Commands281
- Poe Configuration Examples282
Chapter 12: Configuring Emergency Transfer Relay (ETR)285
- Setting ETR State286
- Viewing ETR State287
Chapter 13: Configuring SNMP289
- Agent and Manager Communication289
- SNMP Versions290
- Configuring SNMP Traps295
  - Notification Types296
- Configuring SNMP Access297
- Configuring Dynamic Trap Manager298
- SNMP Configuration Examples299
Chapter 14: Configuring Contact Closure301
- Contact Closure Hardware Configuration301
- Contact Closure Software Configuration302
- Showing Contact Closure Status303
Chapter 15: Transferring and Managing Announcement Files305
- Announcement File Operations305
Chapter 16: Configuring Advanced Switching309
- Configuring Vlans309
- Configuring Port Redundancy (G350 Only)317
- Configuring Port Mirroring320
- Configuring Spanning Tree (G350 Only)321
- Port Classification328
  - Port Classification CLI Commands328
  - Port Classification Configuration Examples328
Chapter 17: Configuring Monitoring Applications331
- Configuring RMON331
  - RMON CLI Commands332
  - RMON Configuration Examples332
- Configuring and Analyzing RTP Statistics333
- Configuring and Analyzing Packet Sniffing372
- Reporting on Interface Status395
- Configuring and Monitoring CNA Test Plugs396
Chapter 18: Configuring the Router403
- Configuring Interfaces403
- Configuring Unnumbered IP Interfaces406
  - Configuring Unnumbered IP on an Interface406
  - Unnumbered IP Examples407
- Configuring the Routing Table408
- Configuring GRE Tunneling411
- Configuring DHCP and BOOTP Relay422
- Configuring DHCP Server424
- Configuring Broadcast Relay430
  - Directed Broadcast Forwarding430
  - Netbios Rebroadcast431
- Configuring the ARP Table431
- Enabling Proxy ARP434
- Configuring ICMP Errors435
- Configuring RIP435
- Configuring OSPF439
- Route Redistribution441
  - Export Default Metric442
- Configuring VRRP442
  - VRRP Configuration Example443
  - VRRP Commands444
- Configuring Fragmentation445
  - Reassembly Parameters446
  - Fragmentation Commands446
Chapter 19: Configuring Ipsec VPN447
- G250/G350 R2.2 VPN Capabilities447
- G250/G350 R3.0 VPN Capabilities448
- G250/G350 R3.1 VPN Capabilities449
- Overview of Ipsec VPN Configuration450
- Overview of Ipsec VPN Components450
- Summary of Configuration Steps452
- Configuring a Site-To-Site Ipsec VPN454
- Ipsec VPN Maintenance471
- Typical Installations474
- Check-List for Configuring Site-To-Site Ipsec VPN527
Chapter 20: Configuring Policy531
- Access Control Lists531
- Defining Policy Lists534
- Attaching Policy Lists to an Interface536
  - Packets Entering the Interface536
  - Packets Exiting the Interface537
- Device-Wide Policy Lists538
- Defining Global Rules539
- Defining Rules539
  - Editing and Creating Rules540
  - Rule Criteria540
- Composite Operations545
- DSCP Table548
  - Changing an Entry in the DSCP Table549
- Displaying and Testing Policy Lists550
  - Displaying Policy Lists550
  - Simulating Packets551
Chapter 21: Configuring Policy-Based Routing553
- Applications554
  - Separate Routing of Voice and Data Traffic554
  - Backup555
- Configuring Policy-Based Routing555
- PBR Rules558
  - Modifying Rules559
  - Rule Criteria559
- Next Hop Lists560
  - Modifying Next Hop Lists560
- Editing and Deleting PBR Lists561
- Displaying PBR Lists562
- Application Example562
  - Configuration for the Sample Policy-Based Routing Application564
  - Simulating Packets567
Chapter 22: Setting Synchronization569
- Synchronization Status570
  - Displaying Synchronization Status570
Chapter 23: FIPS571
- G250 Image and Interfaces571
- G250-BRI Image and Interfaces575
- G250-DCP Image and Interfaces579
- G250-DS1 Image and Interfaces583
- G350 Image and Interfaces587
- Supported Algorithms590
- Security Rules602
- Password Guidelines604
- Managing the Module in FIPS-Compliant Mode604
  - Prerequisites605
- Administration Procedures605
Appendix A: Traps and Mibs627
- G250/G350 Traps627
- G250/G350 MIB Files635
Index697

Other manuals for Avaya G250

User Manual23 pages

Administration Guide840 pages

Maintenance310 pages

Reference812 pages

Installation And Upgrade Guide192 pages

Quick Start For Hardware Installation34 pages

Installing And Upgrading136 pages

Technical White Paper40 pages

Overview76 pages

Backup And Restore Configuration Guide22 pages

Configuring Guide31 pages

Related product manuals

Preview: Avaya G700

Preview: Avaya G650

Preview: Avaya G430

Preview: Avaya G450

Preview: Avaya G350

Preview: Avaya CMC1