Avaya G250 - Administration Guide Manual

840 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

Administration for the Avaya G250

and Avaya G350 Media Gateways

03-300436

Issue 5

June 2008

Table of Contents

Default Chapter3
- Table of Contents3
About this Book25
- Overview25
- Audience25
- Downloading this Book and Updates from the Web25
  - Downloading this Book25
- Related Resources26
- Technical Assistance27
  - Within the US27
  - International27
- Trademarks27
- Sending Us Comments28
Chapter 1: Introduction29
- G250 and G350 Contents29
- G250 and G350 Support Information30
- G250 Available Models31
Chapter 2: Configuration Overview33
- Defining the Console Interface33
- Defining the USB-Modem Interface34
- Defining Other Interfaces34
- Configuration Using CLI35
- Configuration Using GUI Applications35
- Saving Configuration Changes36
  - Summary of Configuration Changes CLI Commands36
- Firmware Version Control37
Chapter 3: Accessing the Avaya G250/G350 Media Gateway39
- Accessing the CLI39
- Accessing the CLI Via Modem42
- Accessing Avaya IW44
  - Access and Run the Avaya IW Using a Laptop Computer45
- Accessing GIW47
  - Access the GIW47
- Accessing PIM48
- Accessing Avaya Communication Manager49
- Managing Login Permissions49
- Special Security Features76
Chapter 4: Basic Device Configuration89
- Defining an Interface89
- Configuring the Primary Management Interface (PMI)90
  - Setting the PMI of the G250/G35090
  - Summary of PMI Configuration CLI Commands91
- Defining the Default Gateway92
  - Summary of Default Gateway Configuration CLI Commands92
- Configuring the Media Gateway Controller (MGC)92
- DNS Resolver98
- Viewing the Status of the Device106
  - Summary of Device Status Commands107
- Software and Firmware Management108
Chapter 5: Configuring Standard Local Survivability (SLS)129
- Media Module Compatibility with SLS129
- SLS Service130
- Avaya Phones Supported in SLS131
- Call Processing in SLS Mode132
- Call Processing Not Supported by SLS133
- Provisioning Data134
- PIM Configuration Data135
- Entering SLS Mode136
- Configuring SLS146
Chapter 6: Configuring Ethernet Ports211
- Ethernet Ports on the G250211
- Ethernet Ports on the G350212
- Configuring Switch Ethernet Ports213
  - Switch Ethernet Port Commands213
  - Summary of Switch Ethernet Port Configuration CLI Commands215
- Configuring the WAN Ethernet Port216
- Configuring DHCP Client218
- Configuring LLDP224
Chapter 7: Configuring Logging229
- Configuring a Syslog Server230
- Configuring a Log File233
- Configuring a Session Log235
- Configuring Logging Filters237
- Summary of Logging Configuration CLI Commands242
Chapter 8: Configuring Voip Qos245
- Configuring RTP and RTCP245
- Configuring Header Compression245
- Configuring Qos Parameters252
- Weighted Fair Voip Queuing (WFVQ)254
  - Configuring Weighted Fair Voip Queueing (WFVQ)254
  - Summary of WFVQ Configuration CLI Commands255
- Priority Queueing256
  - Configuring Priority Queuing256
  - Summary of Priority Queueing Configuration CLI Commands257
Chapter 9: Configuring the G250 and G350 for Modem Use259
- Configuring the USB-Modem Interface259
- Configuring the USB Port for Modem Use259
  - Summary of CLI Commands for Configuring the USB Port for Modem Use261
- Configuring the Console Port for Modem Use262
  - Summary of CLI Commands for Configuring the Console Port for Modem Use263
  - Configuring the Console Device to Connect to the Console Port264
Chapter 10: Configuring WAN Interfaces265
- Serial Interface Overview266
- Initial WAN Configuration268
- Backup Interfaces289
- Modem Dial Backup291
- ICMP Keepalive313
- Dynamic CAC317
- Object Tracking319
- Frame Relay Encapsulation Features337
  - Frame Relay Traffic Shaping and FRF.12 Fragmentation337
- Priority DLCI339
  - Summary of Priority DLCI Commands340
  - PPP Voip Configuration341
Chapter 11: Configuring Poe345
- Load Detection345
  - How the G250/G350 Detects a Powered Device (PD)345
  - Plug and Play Operation346
- Powering Devices347
- Poe Configuration CLI Commands347
- Poe Configuration Examples348
- Summary of Poe Commands350
Chapter 12: Configuring Emergency Transfer Relay (ETR)351
- Setting ETR State352
- Viewing ETR State353
- Summary of ETR Commands353
Chapter 13: Configuring SNMP355
- Agent and Manager Communication355
- SNMP Versions356
- Configuring SNMP Traps361
  - Notification Types362
  - Summary of SNMP Trap Configuration Commands363
- Configuring SNMP Access364
  - Summary of SNMP Access Configuration Commands365
- Configuring Dynamic Trap Manager366
  - Summary of Dynamic Trap Manager Configuration Commands367
- SNMP Configuration Examples368
Chapter 14: Configuring Contact Closure371
- Contact Closure Hardware Configuration371
- Contact Closure Software Configuration372
- Showing Contact Closure Status373
- Summary of Contact Closure Commands373
Chapter 15: Transferring and Managing Announcement Files375
- Announcement File Operations375
- Summary of Announcement Files Commands378
Chapter 16: Configuring Advanced Switching379
- Configuring Vlans379
- Configuring Port Redundancy (G350 Only)386
- Configuring Port Mirroring389
- Configuring Spanning Tree (G350 Only)391
- Port Classification399
Chapter 17: Configuring Monitoring Applications403
- Configuring RMON403
- Configuring and Analyzing RTP Statistics406
- Configuring and Analyzing Packet Sniffing446
- Reporting on Interface Status467
  - Summary of Interface Status Commands468
- Configuring and Monitoring CNA Test Plugs469
- Configuring Echo Cancellation477
  - Echo Cancellation CLI Commands477
  - Summary of Echo Cancellation Commands478
- Integrated Analog Testing - Test and Heal479
Chapter 18: Configuring the Router487
- Configuring Interfaces487
- Configuring Unnumbered IP Interfaces492
- Routing Sources495
- Configuring the Routing Table495
- Configuring GRE Tunneling501
- Configuring DHCP and BOOTP Relay511
- Configuring DHCP Server514
- Configuring Broadcast Relay524
- Configuring the ARP Table526
- Enabling Proxy ARP529
  - Summary of Proxy ARP Commands529
- Configuring ICMP Errors530
  - Summary of ICMP Errors Commands530
- Configuring RIP530
- Configuring OSPF536
- Route Redistribution541
  - Export Default Metric541
  - Summary of Route Redistribution Commands542
- Configuring VRRP542
- Configuring Fragmentation546
  - Fragmentation Commands547
  - Summary of Fragmentation Commands547
Chapter 19: Configuring Ipsec VPN549
- G250/G350 R2.2 VPN Capabilities549
- G250/G350 R3.0 VPN Capabilities550
- G250/G350 R3.1 VPN Capabilities551
- Overview of Ipsec VPN Configuration552
- Overview of Ipsec VPN Components552
- Summary of Configuration Steps554
- Configuring a Site-To-Site Ipsec VPN556
- Ipsec VPN Maintenance573
- Typical Installations576
- Checklist for Configuring Site-To-Site Ipsec VPN629
- Summary of VPN Commands632
Chapter 20: Configuring Policy637
- Types of Policy Lists637
- Managing Policy Lists640
- Defining Policy Lists640
- Attaching Policy Lists to an Interface642
  - Packets Entering the Interface642
  - Packets Exiting the Interface643
- Device-Wide Policy Lists644
- Defining Global Rules645
- Defining Rules645
  - Editing and Creating Rules646
  - Policy Lists Rule Criteria646
- Composite Operations651
- DSCP Table654
  - Changing an Entry in the DSCP Table655
- Displaying and Testing Policy Lists656
  - Displaying Policy Lists656
  - Simulating Packets657
- Summary of Access Control List Commands658
- Summary of Qos List Commands661
Chapter 21: Configuring Policy-Based Routing665
- Applications666
  - Separate Routing of Voice and Data Traffic666
  - Backup666
- Configuring Policy-Based Routing667
- PBR Rules670
  - Modifying Rules671
  - PBR Rule Criteria671
- Next Hop Lists671
  - Modifying Next Hop Lists672
- Editing and Deleting PBR Lists673
- Displaying PBR Lists673
- Application Example674
  - Configuration for the Sample Policy-Based Routing Application676
  - Simulating Packets in PBR679
- Summary of Policy-Based Routing Commands679
Chapter 22: Setting Synchronization683
- Synchronization Status684
  - Displaying Synchronization Status685
  - Summary of Synchronization Commands685
Chapter 23: FIPS687
- G250 Image and Interfaces687
- G250-BRI Image and Interfaces691
- G250-DCP Image and Interfaces695
- G250-DS1 Image and Interfaces699
- G350 Image and Interfaces703
- Supported Algorithms706
- Security Rules718
- Password Guidelines720
- Managing the Module in FIPS-Compliant Mode720
  - Prerequisites721
- Administration Procedures721
Appendix A: Traps and Mibs743
- G250/G350 Traps743
- G250/G350 MIB Files751
Index813

Other manuals for Avaya G250

User Manual23 pages

Administration720 pages

Maintenance310 pages

Reference812 pages

Installation And Upgrade Guide192 pages

Quick Start For Hardware Installation34 pages

Installing And Upgrading136 pages

Technical White Paper40 pages

Overview76 pages

Backup And Restore Configuration Guide22 pages

Configuring Guide31 pages

Related product manuals

Preview: Avaya G700

Preview: Avaya G650

Preview: Avaya G430

Preview: Avaya G450

Preview: Avaya G350

Preview: Avaya CMC1