Avaya G450 - Default Actions; Deleting a Policy List; Attaching Policy Lists to an Interface; Packets Entering the Interface

Configuring policy
596 Administration for the Avaya G450 Media Gateway
Default actions
When no rule matches a packet, the G450 applies the default action for the list. The following
table shows the default action for each type of policy list:
Deleting a policy list
To delete an access control list, enter no ip access-control-list followed by the number
of the list you want to delete. To delete a QoS list, enter no ip qos-list followed by the
number of the list you want to delete.
Attaching policy lists to an interface
Attached to each interface on the Avaya G450 Media Gateway are policy lists, including the
ingress access control list, ingress QoS list, egress access control list, and egress QoS list.
Note:
Note: You can also attach PBR lists to certain interfaces, but PBR lists are not attached
to any interface by default.
Packets entering the interface
When a packet enters the G450 through an interface, the G450 applies the policy lists in the
following order:
1. Apply the ingress access control list.
2. If the ingress access control list does not drop the packet:
a. Apply the ingress QoS list.
b. Apply the PBR list (if any).
The packet enters the G450 through the interface.
List Default action
Access control list Accept all packets
QoS list No change to the priority or DSCP