Important notice about rack safety
One prerequisite to installing the switch in an equipment rack is to bolt the equipment rack to the
floor. This section emphasizes the safety issue if you do not bolt the rack to the floor.
Warning:
If you pull the chassis all the way out on the slide rails, there is a danger of the rack tipping over.
This can happen if your equipment rack is not bolted to the floor and there are no other devices
installed as shown in the following figure. To avoid this danger, refer to the guidelines in the
graph below the figure.
If your rack meets the following guidelines and you pull the chassis all the way out, the rack is in
danger of tipping over:
• 900mm equipment rack that weighs less than 14kg
• 600mm equipment rack that weighs less than 21kg
• 300mm equipment rack that weighs less than 42kg
January 2015 Installation Job Aid for Avaya Virtual Services Platform 7200 Series 29
To Next Page
Loading...
