Original Operating Manual 1-2013
→ Speed and distance indications
The speed indication (e) always shows the actual speed of the Hybrid bike.
The function indication (= text in c and value in d) comprise the following options:
‘range‘: range being estimated on actual battery charge, provided that all other con-
ditions like support level, route profile etc. remain the same
‘distance‘: driving distance measured since last re-set
‘travel time‘: driving time measured since last re-set
‘avg. speed‘: speed average calculated on driving data since last re-set
‘max. speed‘: maximal speed achieved since last re-set
‘clock‘: actual time
To change the indication function, press button ‘ i ‘ (1) on the operating computer or button ‘ i ‘
(11) on the operating unit repeatedly, until the desired function appears
To re-set ‘distance’, ‘travel time’, ‘average speed’ go to one of the three functions, and then
press the 're-set' (6) as long until the indication is set to zero. This also re-sets the values of the
other two functions. To re-set ‘maximum speed‘, select it and press re-set until it is set to zero.
When the operating computer is removed from the holder (4), all values of the functions will be
stored and can be displayed during mobile use.
→ Display/adapt basic settings
The basic settings can be displayed and changed, no matter if the operating computer Intuvia is
in the holder (4) or not. To access the basic settings menu, press and hold the ‘re-set’ button (6)
and the ‘ i ’ button (1) until ‘configuration’ is displayed in the text indication (c).
To switch between the basic settings, press the ‘ i ’ button (1) on Intuvia until the desired basic
setting is displayed. When the operating computer is inserted in the holder (4), you can also
press the ‘ i ’ button (11) on the operating unit.
To change the basic settings, press the on/off button (5) next to the ‘ – ‘ indication to decrease
the value or scroll down, or the light button (2) next to the ‘ + ‘ indication to increase the value
or scroll up.
When the operating computer is attached to the holder (4), you can also change the values
with the ‘ – ‘ button (12) or the ‘ + ‘ button (13) om the operating unit. To exit the function and
store a changed setting, press the ‘re-set’ button (6) for three seconds.
The following basic settings are available:
‘unit km/mi’ speed and distance can be displayed either in kilometres or miles
‘time format’ time can be displayed either in 12 hours or 24 hours format
‘clock’ actual time can be set here. Press and hold the setting button, fast-
forward the speed of setting
‚English’ language for text indication can be changed. The available languages are
German, English, French, Spanish, Italian and Dutch
To Next Page
Loading...