avenli 17618 Series - Usage; Filtration and Heating Functions; Pool Cover and Security; Maintenance

EN
Press the lter button to activate the water ltration. The green indicator light will
turn on when the ltration system is activated.
Note:
- If massage function is on, the ltration can’t be activated.
Press the heating button to activate water heating and ltering system at the
same time. The green indicator light of lter and red indicator light of heating will
turn on at same time
The pump does not stop heating until the current water temperature reaches the
set temperature; and the heating system will restart after the current water tem-
perature drops 2°C below the set temperature automatically.
Maximum heating temperature: 40°C (104°F)
Important :
After 150 cumulative hours of ltration operation, the message “CHG FIL”
is displayed on the lter block. This message is an automatic reminder to
indicate that it is time to change the lter cartridge.
To delete the message, hold the “lter” button for 5 seconds.
Note :
- With the heating system staring, the ltration system will start working together.
- After turning off the heating system, the ltration system will still work.
- If the massage function is active, the ltration and heating functions can not be activated.
4.3. Pool cover and security
After each use, the control panel must be locked and the pool must be coated with its
top cover and it must be attached to the base protector with the safety buckles.
Each safety buckles has a lock system ; closed buckle, the latch in up position locks
the buckle, the latch in down position unlocks the buckle.
The top cover keeps the heat from the water and secures the pool.
4. USAGE
5.1. Water maintenance
WARNING : A bad pool water quality can harm your health.
Depending on the frequency and conditions of use:
- The lter cartridge should be regularly cleaned (150 hours max.).
- The lter cartridge should be replaced every 1 to 2 month.
- The pool water should be changed every 15 to 30 days.
Use a water test kit to control the parameters of the water before using the spa, or at
least once a week.
Use disinfection products for the spa. The treatment products should be used with
caution and it is imperative to refer to their instructions.
Damage resulting from improper use of treatment products is not covered by warranty
(overdose, shock treatment, ...).
1. Water balance
The water balance (pH) must be maintain between 7 and 7.4.
2. Water Sanitation
To sanitize the pool water, we suggest using an active oxygen-based
treatment or bromine placed in a oating dispenser. (Dispenser sold
separately).
5. MAINTENANCE
5.2. Cleaning and replacing lter cartridge
Dirty lter cartridge may contaminate the pool water and cause damage to the heating
function.
1. Unscrew the lter case by turning it counter-clockwise. Take out the lter cartridge
from the case.
2. Rinse off the lter cartridge with a garden hose. If the lter cartridge remains dirty
and discoloured, the lter cartridge should be replaced.
3. Put back the cleaned lter cartridge into his case and screw it to the pool.
Disinfection
Water Sanitation:
To sanitize the pool water, we suggest using an active oxygen-based treatment or bro-
mine placed in a oating dispenser. (Dispenser sold separately)
If water is heavily polluted you should not use pool.
Clean pool with with specialist UV lighting equipment.
Seek professional advice and guidance before doing this.
Attention:
Detergent residues and dissolved solids from bathing suits and chemicals may build
up on the spa walls, Use soap and water to clean the walls and rinse thoroughly with a
garden hose using a direct powerful waterspray
12 13