US
8 9
WARNING: The GFCI plug must be tested before each use.
Do not use if GFCI test fails and see chapter 6.1.
3.1. Site selection
Place in a clean environment Ensure its levelUse a sun cover
WARNING : Before proceed to installation your spa, please make sure that the
selected location meets the following conditions :
• A level place in order to avoid any defect, hernia or leakage.
• Wide enough to support the spa and its pump unit.
•
• Sheltered from the sun and bad weather.
• Clean and free from sharp objects.
• Devoid of aggressive vegetation on the ground.
Failure to comply with these rules may result in property damage or personal injury.
3. INSTALLATION
1. Insert the plug into the power outlet.
2. Press the <<RESET>>button,the indicator light turns red.
3. Press the <<TEST>>button,the indicator light turns off.
4. Press the <<RESET>>button,the indicator light turns red.
The GFCI works properly.
3.3. Assembling
ground cloth.
1) Place the ground cloth in the
chosen location. spa.
pump on the socket .
10 minutes. Ensure that the spa is
12) Ensure that the drain caps are
the spa
13) Fill the SPA with 10 cm of water.
9) Connect the unit pump to the spa
using the 3 connectors to screw.
Ensure the icons on the pump and the
spa match up
then screw the cartridge onto the lower
suction connection joint.
6) Connect the pump unit then press
located in the back of the pump unit.
To Next Page
Loading...
