US
14 15
Here are some useful tips to help you to diagnose and rectify common problems.
Reference
recirculated back into the spa from the heater unit.
Problem Cause Solution
Control panel
screen does not
operate
Check power source
Power failure
power of the pump unit.
Call for service if it does not reset
SPA pump does not
heat properly
Temperature set is too low Set to a higher temperature
Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)
Too low water level Fill water to minimum water level
Heating element defective Call for service
Bubble massage
system does not
work
Pump is overheating Cut off the power and wait until the pump has cooled.
activated
Press the bubble button to reactivate
Malfunction of the pump unit Call for service if it does not reset
not work
Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)
Inlet and outlet blocked Clean the inlet and outlet
Air inside the pump Fill water to minimum water level
Malfunction of the pump unit Call for service if it does not reset
Pump leakage
Adaptor seal improperly Replace the seal in the right position
Water leakage from pump body Check the pump body, call for service
Spa spa leakage Spa spa is torn or punctured Use provided repair kit (see chapter 5.4)
Water is not clean
Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)
Change the spa water completely
Improper water treatment Refer to the chemical manufacturer’s instructions
CHG FIL
6. TROUBLE SHOOTING
6.1. Troubleshooting
7. WARRANTY
If the screen displays an error code “Ex”, please refer to the table below.
E3, E4, E5, E6 error code
If error code is still displayed on the control Box, please do the following instrutions :
1 - Check that the water line is between the high and low limits.
3 - Unscrew and clean the 2 nozzles (Entry and exit of water) inside the spa and remove wastes if necessary (Neaf, hairs, fur,
skin...)
foreign matter.
Cut the spa again electrically for 5 minutes and re-connect it, if the error code is still displayed on the control box please contact
the Service Center.
7.1. Error code
Code Situation Problem Cause Ss olutions
E1
Not heating Not
heating properly.
Wrong temperature
control sensor.
Temperature control sensor short
circuit or open circuit.
Contact service center.
E3
Not heating
properly.
High water tempera-
ture indicator.
(113°F).
water is between 2°C~44°C (36°F~111°F)
· Cut off the power then remove the pump.
After that clean the scale on the in/outlet.
· If this does not solve the problem, refer
to the box below
E4
All functions do
not work, buzzing
warn.
Low water tempera-
ture indicator.
The pool water is lower than 2°C
(36°F).
water is between 2°C~44°C (36°F~111°F)
· If this does not solve the problem, refer
to the box below
E5
All functions do
not work, buzzing
warn.
High water tempera-
ture indicator.
(122°F).
-
cian to reset the thermal cutout described
in next paragraph.
· If this does not solve the problem, refer
to the box below
E6
Not heating and
Buzzing warns.
Water pressure is
not big enough to
activate heating.
·Inlet or outlet on inner wall are
blocked.
·Filter cartridge is too dirty.
·Pool water does not reach mini-
mum water level.
·Do not release air from pump
Pump is wrong”
·Clean inlet and outlet
·Add water to reach water level
·Do air release as outlined again
· If this does not solve the problem, refer
to the box below
To Next Page
Loading...
