avenli SPA - Spa Usage and Control Panel; Control Panel Functions; Operation Modes and Notes; Spa Cover and Security

US
10 11
Once powered-up, the LED displays the current water temperature automatically.
The temperature units selector changes the temperature units from Celsius de-
grees to Fahrenheit degrees.
Press the temperature adjustment buttons, then the screen will ash. When it is
ashing, you can set the desired temperature. The value will increase or decrease
1 degree at once. The temperature could be set between 30°C to 40°C (86°F to
104°F).
To lock or unlock the control panel, press the Lock button and hold 3 seconds.
Lock the control panel when you are away to prevent other people come to
change your settings..
Press the massage button to activate the bubble massage system, the green
indicator light turns on. It can be turned off by pressing it again.
Note :
- The massage system will stop automatically after 30 minutes of operation. Re-activate the mas-
sage function by pressing the massage button again.
- When lter button is on, pressing bubble button will exchange lter mode into massage mode: lter
indicator light will turn off and massage indicator light turn on. If press the bubble button again, the
massage mode will be changed back to lter mode.
4. USAGE
4.1. Control panel
4.2. Functions
Filtration
Temperature
Decrease Button
Temperature
Increase Button
LED Display
Massage Button
Lock Button
Temperature
units indicator
Temperature
units
selector
Heat Button
Press the lter button to activate the water ltration. The green indicator light will
turn on when the ltration system is activated.Please note that lters should be
changed every 7 days, or until they become discolored.
Note:
- If massage function is on, the ltration can’t be activated.
Press the heating button to activate water heating and ltering system at the
same time. The green indicator light of lter and red indicator light of heating will
turn on at same time
The pump does not stop heating until the current water temperature reaches the
set temperature; and the heating system will restart after the current water tem-
perature drops 2°C below the set temperature automatically.
Maximum heating temperature: 40°C (104°F)
Important :
After 150 cumulative hours of ltration operations, an audible alarm will
sound and the LCD display will show the characters CHG, followed by FIL,
to remind you to change or clean the lter. You can hold the ltering button
5 seconds to turn off the buzzing. The ltering system will turn off, you can
press the button to active the ltering system again.
Note :
- With the heating system staring, the ltration system will start working together.
- After turning off the heating system, the ltration system will still work.
- If the massage function is active, the ltration and heating functions can not be activated.
4.3. Spa cover and security
After each use, the control panel must be locked and the spa must be coated with its
top cover and it must be attached to the base protector with the safety buckles.
Each safety buckles has a lock system ; closed buckle, the latch in up position locks
the buckle, the latch in down position unlocks the buckle.
The top cover keeps the heat from the water and secures the spa.