Warnings
Cleaning the scale
For your protection, all mains (110V or 230V) equipment used where damp or
wet conditions may occur, must be supplied from a correctly fused source and
protected by an approved RCD to BS7071 or BS7288 or IEC1008-2-2 BS EN
61008:1995. IF IN DOUBT SEEK ADVICE FROM A QUALIFIED
ELECTRICIAN.
To avoid the possibility of electric shock or damage to the machine, always
isolate from the mains power supply before carrying out any routine
maintenance.
Harsh abrasives, solvents, scouring cleaners and alkaline cleaning solutions,
such as washing soda, should not be used especially on the display windows.
Under no circumstances should you attempt to wipe the inside of the machine.
The outside of the machine may be wiped down with a clean cloth moistened
with water containing a small amount of washing up liquid.
To Next Page
Loading...
