EasyManua.ls Logo

Avid Power AHCAP068 - Technical Specifications

Avid Power AHCAP068
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ATTENTION
TECHNICAL SPECIFICATIONS
1. The product only can be used on DC 12V power source and it can’t be
used directly on AC 110V, AC 220V, DC 24V, DC 36V.
2. Avoid over-inflating, never exceed the recommended pressure. Items
over inflated may burst and cause serious injury. Allow device to cool
for 10 minutes after 15 minutes of continuous operation.
3. The unit will become hot during use and we recommend to wear
protective gloves when operation. Use caution when touching the
unit. Only cautiously hold the unit by the carry handle and allow the
unit to cool enough before storing.
WARNING
Make sure the vehicle has safely stopped, then start the
engine. Before plugging power cord into the cigarette lighter
socket of the car, please check whether the car’s maximum
current reaches 20 amps. If lower than 20 amps, DO NOT use
a cigarette lighter to supply power to inflate, avoiding short
circuit of the car, please use the special battery clamps instead!
Voltage DC 12V
Rating Power 220W
Max Flow 46L/min
Max Display Pressure 150 PSI
Max Current 18A
Power cord 2.8m
Air hose 0.65m
LED 300 LUM
2