6
HOW TO INFLATE CAR TIRE
To prevent blowing fuse, please turn on the pump before connecting it
to tire valve stems.
To prevent compressor damage: if compressor shuts off automatically,
allow to cool for 10 minutes before restarting. Compressor shuts off to
prevent overheating damage.
REPLACE THE FUSE
A
B
C
1. Unthread and remove the Bezel (A).
2. Slide the Fuse (B) out of the Lighter Adapter.
3. Insert a new Fuse.
4. Recombine the Bezel.
To replace the fuse located inside the Lighter Adapter, please follow these
steps (See Figure below):
If the unit would not turn on or abruptly turn off during operation, check
the following:
a. Is the Lighter Adapter fully and securely inserted into the vehicles 12
volt power supply?
b. Has the fuse inside the Lighter Adapter blown? If so, replace the fuse.
To Next Page
Loading...