Figure 1: Example application.
1. Dark Red — +12 VDC, 50 mA max. output for relay drive
2. Grey — Relay ground return
3. Red — Relay input 1
4. Orange — Relay input 2
5. Pink — Relay output 1
6. Blue — Relay output 2
l * — Relay
l ** — Switch
NOTE: The 12 V connection can be used to energize a relay coil with up to 50 mA. If more than 50 mA is
required, an external power supply up to 25 VDC at 120 mA can be used.
l White — Audio/video analog ground return
l Brown — Analog audio input
l Green — Analog audio output
l Yellow — Analog video output
l Black — not connected
l Purple — not connected
The camera can be connected to an external microphone, speaker and video monitor through the I/O
connector.
NOTE: The camera only supports line level mono audio input and an NTSC or PAL video output.
Connecting to External Devices 15
To Next Page
Loading...