Setup
NOTE: Some options are disabled if they are not supported by the camera, or if you do not have the required
user permissions.
The device’s factory default settings allow you to use the camera or encoder immediately after installation. If
you have special requirements, you can customize the settings through the web interface.
A Restore Default button is available on each Setup page to allow you to restore the factory default settings.
Be aware that some of the settings are only available through the camera web interface and can not be changed
in the network video management software.
For the settings that are specific to PTZ cameras, see PTZ Camera on page25.
For the settings that are specific to encoders, see Encoder on page28.
General
When you select the Setup link, the first page you see is the General page. The General page allows you to set
the device identity.
1. In the Name field, give the device a meaningful name.
2. In the Location field, describe the device’s location.
3. Select the Disable camera status LEDs check box to disable the LEDs located on the device.
Setup 7
To Next Page
Loading...
