1. The entire field of view is highlighted for motion detection by default. To define the motion detection
area, use any of the following tools:
l Click Clear All to remove all motion detection areas on the video image.
l Click Set All to set the motion detection area to span the entire video image.
l To set a specific motion detection area, click Select Area then click and drag anywhere on the
video image.
l To clear a specific motion detection area, click Clear Area then click and drag over any motion
detection area.
l Use the Zoom In and Zoom Out buttons to locate specific areas in the video image.
2. In the Sensitivity field, enter a percentage number to define how much each pixel must change before it is
considered in motion.
The higher the sensitivity, the smaller the amount of pixel change is required before motion is detected.
3. In the Threshold field, enter a percentage number to define how many pixels must change before the
image is considered to have motion.
The higher the threshold, the higher the number of pixels must change before the image is considered to
have motion.
4. Click Apply to save your changes.
16 Motion Detection
To Next Page
Loading...
