Avigilon H3-DP1 - Using the Encoder PTZ Controls

1. To zoom the camera:
l Adjust the Zoom slider.
l Or, click and drag to create a green box on the image panel to define the area you want to zoom in
to see.
2. To move the camera:
l Click anywhere on the image panel to center the camera to that point.
l Or, drag your mouse from center to move the camera in that direction. The farther the arrow is from
center, the faster the camera will move.
3. To perform a guard tour, select a tour from the drop down list then click Start. To setup a tour, see PTZ
Tours on page25.
4. To stop a guard tour, click Stop. You can pause a tour at any time just by using the other PTZ controls.
Using the Encoder PTZ Controls
Any camera that is connected to an H.264 encoder can have the PTZ option enabled. Once enabled, the full
pan, tilt and zoom controls are displayed in the Live View for that camera.
To enable PTZ for cameras that are connected to an encoder, see Setting Up PTZ on page28.
Using the Encoder PTZ Controls 5