Motion Detection
On the Motion Detection page, you can define the green motion detection areas in the camera’s field of view.
Motion detection is ignored in areas not highlighted in green.
To help you define motion sensitivity and threshold, motion is highlighted in red in the image panel.
NOTE: This motion detection setting configures pixel change detected in the camera's field of view. If you are
configuring an Avigilon™ video analytics camera, you will need to configure the detailed analytics motion
detection and other video analytics features through the Avigilon™ Control Center Client software. For more
information, see the Avigilon Control Center Client User Guide.
1. The entire field of view is highlighted for motion detection by default. To define the motion detection
area, use any of the following tools:
l Click Clear All to remove all motion detection areas on the video image.
l Click Set All to set the motion detection area to span the entire video image.
l To set a specific motion detection area, click Select Area then click and drag anywhere on the
video image.
l To clear a specific motion detection area, click Clear Area then click and drag over any motion
detection area.
l Use the Zoom In and Zoom Out buttons to locate specific areas in the video image.
2. In the Sensitivity field, enter a percentage number to define how much each pixel must change before it is
considered in motion.
16 Motion Detection
To Next Page
Loading...
