l Sequential: the PTZ camera will go to each preset in the set order.
l Random: the PTZ camera will go to each preset in random order.
5. Select the Set as default tour check box if you want this tour to run automatically.
l The Default Tour Idle Start Time field is now enabled, enter the amount of time the PTZ camera
must be idle for before this tour automatically begins.
6. To add a preset, click Add Preset and a preset is added to the list.
a. In the Preset column, select a preset from the drop down list.
b. In the Move Speed column, enter how fast you want the PTZ camera to move to this preset. The
speed is 80% by default.
c. In the View Time column, enter the amount of time you want the PTZ camera to stay at this preset
position. The view time is 10 seconds by default.
d. Continue until all the presets for this tour have been added.
7. To remove a preset, click the (x) icon to the far right of the preset.
8. To re-order a preset, click the up and down arrows or click and drag the left edge of the preset through
the list.
9. Click Apply to save the tour.
Editing PTZ Tours
1. Among the Setup options, click PTZ Tours.
2. Click Edit.
3. Make the changes you need.
4. To undo the changes that you’ve made, click Discard Changes.
5. Click Apply to save your changes.
6. To delete the tour, click Delete Tour. When the confirmation dialog box appears, click OK.
PTZ Limits
Depending on where the PTZ camera is installed, you may want to limit the movement and zoom of the camera
so that obstructions are never in view. For example, if the PTZ camera is installed close to the side of a building,
you can set the limits so that the PTZ camera cannot move to show the wall it is installed against.
Editing PTZ Tours 29
To Next Page
Loading...
