User’s Manual
The following options are only available when Fixed to
Transport is selected.
X-Offset — the distance from the left end of the scanner
to the left edge of the scanning area.
Y-Offset — the position from the top end of the document
to the top end of the scanning area.
Width — the width of the scanning area.
Length — the length of the scanning area.
Center: automatically calculates the x-offset for center-fed
feeding based upon document size selected.
— relocate the scan area by click the arrow key on the
cross sign while retain the scan size. View the result from
the Display window.
The Adjustment option is available when Automatic is
selected.
Adjustment —adds a positive/negative margin value
Top/Bottom or toward left/right of the image. Adjustment
is used when the automatic document feeder is used.
Adjustment reduces the possibility of corner clipping on
skewed images. To set Adjustment values, use the UP/Down
buttons to select where you want to apply Adjustment
values: Top/Bottom or Left/Right, and then select the
amount of inches/mm/pixels applied. Select a value within
the range of 0.00 to 1.00 / -1.00.
To Next Page
Loading...
