User’s Manual
Notes to print the patch codes:
Use blank white paper.
Set the scaling to 100%. The sheet is not recognized
al.
id bleed-through from
copy a patch code sheet that you printed out,
heet repeatedly may decrease the
e sheets.
correctly when printed in a size smaller than the origin
Do not use toner saving mode. The sheet is not recognized
correctly when the print is too light.
Do not use thin paper in order to avo
the back.
When you
make sure to copy by the same size and brightness as the
original copy.
Use the same s
recognition accuracy due to accumulated dirt on th
If the sheet is not recognized correctly or gets smudged,
replace it with a new sheet.
4-71
To Next Page
