Afeter you send the command of SMS to device,it will reply to your
mobile phone: Receive:’016’OK
*000000,016,1#
2.2.2 Set the sleep mode
Step1: open the sleep mode and the tremble sensor
Format: *$$$$$$,021,XY#
X: close/open the sleep mode
Y: close/open the tremble sensor
For example: *000000,021,11#
When you want to use the sleep mode of function,make sure
open the sleep mode and tremble sensor
Afeter you send the command of SMS to device,it will reply to your
mobile phone: Receive:’021’OK
*000000,021,11#
Step2: set the time of no tremble into the sleep.
Format: *$$$$$$,044,X#
X: After the tremble sensor don't tremble for X second, tracker
will into sleep mode(unit：sec)
For example：*000000,044,60#
If the device don't tremble for 60 sec,the device will into the
sleep mode.
Afeter you send the command of SMS to device,it will reply to your
mobile phone: Receive:’044’OK
*000000,044,60#
Step 3: set the time of tremble to wake up the device
Format: *$$$$$$,043,X#
X: After the tremble sensor continuous tremble for X second,
device will wake up.
For example: *000000,043,30#
To Next Page
Loading...
General