1. Click "Telephony" in the FRITZ!Box user interface.
2. Click "Telephony Devices" in the "Telephony" menu.
3. Click the (Edit) button for the respective telephone.
4. Click on the "Do Not Disturb" tab, disable any "Do Not Disturb" settings, and click "OK".
5. Click "Telephony" and then "Call Handling", and delete all call blocks.
6. Click on the "Call Through" tab. If the tab is not displayed, enable the Advanced View.
7. Disable call through and click "Apply".
5 Disabling "DECT Eco"
1. Click "DECT" in the FRITZ!Box user interface.
2. Click "Base Station" in the "DECT" menu.
3. Disable the option "DECT Eco" in the "Radio Field Strength" section.
4. Click "Apply" to save the settings.
If the telephone rings now, the DECT connection to the telephone was disturbed. Any devices that emit
radio waves could be a source of interference. These include other DECT base stations, baby monitors,
mobile telephones, and television antennas, for example. If the telephone does not receive the "wake up"
signal from the FRITZ!Box in time and therefore does not wake up from standby mode, repositioning the
telephone may help.
6 Assigning telephone numbers to telephones
1. Click "Telephony" in the FRITZ!Box user interface.
2. Click "Telephony Devices" in the "Telephony" menu.
3. Click the (Edit) button for the respective telephone.
4. Configure the telephone so that it reacts to incoming calls to the desired telephone number: Enter
the number under "Outgoing calls" or "Incoming calls", or enable the option "React to all numbers".
5. Click "OK" to save the settings.
7 Maintaining a permanent internet connection
Calls to your internet telephone number can only reach the FRITZ!Box if an internet connection is active.
Some FRITZ!Box models must be configured to permanently maintain the internet connection:
1. Click "Internet" in the FRITZ!Box user interface.
To Next Page
Loading...
Need help?
General