If your telephone reacts to several numbers, you can configure a special ring tone for each of the
telephone numbers. This way you can immediately tell which number the caller dialed when you receive
a call:
1. Click "DECT" in the FRITZ!Box user interface.
2. Click "Cordless Telephones" in the "DECT" menu.
3. Click the (Edit) button for the respective telephone.
4. Enable the option "React only to the following numbers".
5. Select the numbers the telephone should react to when you receive calls.
Note:After assigning ring tones, you can once again enable the option "React to all numbers".
6. Click "OK" to save the settings.
7. Click the (Edit) button for the respective telephone.
8. Click on the "Ring Tones" tab.
9. From the drop-down lists, select the desired ring tone for all of the telephone numbers.
10. Click "OK" to save the settings.
3 Assigning ring tones to specific telephone book entries
With your telephone you can assign special ring tones to individual telephone book entries so you can
immediately tell who is calling you:
1. Press the "Menu" key on the telephone.
2. Scroll to "Telephone book" and press "OK".
3. Scroll to the desired entry and press "OK".
4. Select "Change" and then press "OK".
5. Under "AVM ring tone", select the current ring tone and press "OK".
6. Select the desired ring tone from the list and press "OK".
7. Press "OK" to save the settings.
4 Configuring ring tones for internal calls, important persons, and the alarm
1. Click "DECT" in the FRITZ!Box user interface.
2. Click "Cordless Telephones" in the "DECT" menu.
3. Click the (Edit) button for the relevant telephone.
To Next Page
Loading...
Need help?
General