Avnet Ultra96-V2 - Getting Started Guide Manual

44 pages

Save Page as PDF

To Next Page

Page 1

trademarks of Avnet, Inc. All other brands are the property of their respective owners.

LIT# Ultra96-V2-GSG-v2-0

Ultra96-V2 Getting Started Guide

Version 2.0

Main Page

Default Chapter3
- Table of Contents3
1 Getting Started with Ultra96-V26
- Figure 1 - Ultra96-V26
2 What's Inside the Box7
- Optional Add-On Items7
3 What's on the Web8
- Official Documentation8
- Tutorials and Reference Designs8
- Trainings and Videos8
4 Ultra96-V2 Key Features9
- Figure 2 - Ultra96-V2 Block Diagram10
5 Ultra96-V2 Basic Setup and Operation11
- Figure 3 - Ultra96-V2 Topology11
6 Example Design12
7 Run the out of Box Design12
- Figure 4 - Ultra96-V2 SW3 Boot Mode Switch Location12
- Figure 5 - Ultra96-V2 with Older 3-Pin JTAG/UART Pod13
- Figure 6 - Ultra96-V2 with Newer 4-Pin JTAG/UART Pod14
- Figure 7 - Press the SW4 Power on Button15
8 Connect to Webserver16
- Figure 8 - Ultra96-V2 as an Available Network16
- Figure 9 - Connected to Ultra96-V2 Webserver17
9 Ultra96-V2 GPIO Leds Example Project18
- Figure 10 - Ultra96-V2 User Leds18
- Figure 11 - Ultra96-V2 GPIO Leds18
- Figure 12 - LED0/D3 Changed to Steady-State on19
10 Tutorials20
- Figure 13 - Ultra96-V2 Tutorials20
11 Access Ultra96-V2 Linux Terminal over SSH21
- Figure 14 - Teraterm New Connection21
- Figure 15 - SSH Terminal Settings22
- Figure 16 - Click Continue22
- Figure 17 - SSH Authentication23
- Figure 18 - Ultra96-V2 Terminal23
12 Connect to External Wi-Fi24
- Figure 19 - Wifi Setup24
- Figure 20 - Discovering Networks24
- Figure 21 - Successfully Connected25
- Figure 22 - Determine IP Address Assigned to Ultra96-V225
- Figure 23 - Connected to Ultra96-V2 Via External Wi-Fi26
13 Reading On-Board Telemetry27
- Figure 24 - I2Cdetect27
- Figure 25 - PMIC on I2C Mux Channel 427
- Figure 26 - Pmics on I2C-628
- Figure 27 - Telemetry from PMIC 0X15/4528
- Figure 28 - Telemetry from PMIC 0X13/4329
- Figure 29 - Telemetry from Mpsoc Sysmon29
- Figure 30 - Telemetry from PMIC 0X14/4430
14 PMIC Version Check and Update31
- PMIC Version Checking31
- Figure 31 - PMIC Config Files31
- Figure 32 - Pmics Detected on I2C Bus 633
- Figure 34 - Compare PMIC Config to a File, 0X13 or 0X1434
- Figure 35 - Compare PMIC Config to a File, 0X1534
- PMIC Reprogramming35
- Figure 36 - Carefully Read, then Confirm to Proceed35
- Figure 37 - Programming 0X13 Succeeded35
15 Power off37
- Figure 38 - Power down Initiated through Short Press of SW437
16 Getting Help and Support38
- Avnet Support38
- Xilinx Support39
17 Installing and Licensing Xilinx Software40
- Install Vivado Design Suite, Design Edition40
- Figure 39 - Voucher Confirmation41
- Figure 40 - Generate Node-Locked41
- Figure 41 - Select Host Information42
18 Certification Disclaimer44
19 Safety Warnings44
20 RF Certification44

Avnet Ultra96-V2 - Getting Started Guide Manual

Table of Contents

Other manuals for Avnet Ultra96-V2

Related product manuals