56 DSR Switch Installer/User Guide
The Search Password field is used to authenticate the administrator or user specified in the Search
DN field.
Use the Search Base field to define a starting point from which LDAP searches begin. The
modifiable default values are dc=yourDomainName and dc=com. For example, to define a search
base for test.com, type
dc=test, dc=com. Each Search Base value must be separated by a comma.
The UID Mask field specifies the search criteria for User ID searches of LDAP target devices. The
format should be in the form <name>=<%1>. The default value is sAMAccountName=%1, which
is correct for use with Active Directory. This field is required for LDAP searches.
Figure 4.4: LDAP Search Page in the On-Board Web Interface
To configure LDAP search parameters:
1. Select Appliance - Appliance Settings - User Accounts - LDAP Accounts - Search.
2. Enter the appropriate information in the Search DN, Search Password, Search Base and UID
Mask fields.
3. Click Save.
NOTE: These options cannot be changed if the LDAP Priority is set to LDAP Disabled on the Overview screen.
To Next Page
Loading...
