To Next Page

To Previous Page

SwitchView User Manual

Key Sequence Action

<CTRL><CTRL>Addr<Enter> Selects an active channel via keyboard.

<CTRL><CTRL>Dnn<Enter> Congures the dwell time. Substitute nn with

a value from 2 to 60 seconds.

<CTRL><CTRL>SG<Enter> Enables the scan Go command.

<CTRL><CTRL>SH<Enter> Enables the scan Halt command.

<CTRL><CTRL>M+<Enter> Mouse will suspend scanning.

<CTRL><CTRL>M-<Enter> Mouse will not suspend scanning. (default)

<CTRL><CTRL>MR<Enter> If you hot-plug the SwitchView to a PC con-

nection you may experience a loss of mouse

signal. Use this command to restore the signal

if you’re using a PC with a standard PS/2

mouse driver. (See page 8)

<CTRL><CTRL>MW<Enter> Use this command to restore the mouse signal

if you’re using a PC with a Microsoft Intel-

liMouse driver. (See page 8)

<CTRL><CTRL>Kn<Enter> Sets keyboard scan set; n is a number 1 - 3.

<CTRL><CTRL>AV<Enter> Displays the current rmware version of the

SwitchView processors. You must be at a DOS

prompt or in a text editor/word processor to

view this information.

<CTRL><CTRL>H1<Enter> Default Command Mode Activation

<CTRL><CTRL>H2<Enter> Changes the Command mode activation

sequence to <ALT> <ALT>

<CTRL><CTRL>H3<Enter> Changes the Command mode activation

sequence to <Shift> <Shift>

<CTRL><CTRL>H4<Enter> Changes the Command mode activation

sequence to <NUMLOCK> <->

<CTRL><CTRL>ZM<Enter> Used to resynchronize the mouse after a hot-

plug. Repeat, if necessary, until synchroniza-

tion is re-established.

NOTE: Using this command while the mouse

is operating correctly will cause the mouse

to lose sync.

Appendix

The following is a summary of all operational commands.

Avocent SwitchView User Manual

Other manuals for Avocent SwitchView