avolta A007E-10C - Cooling and Dehumidifying Operations; Fan and Heating Operations; Timer Operation Settings; Water Drainage

16
Check up whether the exhaust hose has been mounted properly.
Cautions for cooling and dehumidifying operations:
- When using functions on cooling and dehumidifying, keep an interval of at least 3 minutes
between each POWER.
- Power supply meets the requirements.
- The socket is for AC use.
- Do not share one socket with other appliances.
- Power supply is AC220-240V，50Hz
2. Cooling operation
- Press the “Mode” button till the “Cool” icon appears.
- Press the “▲”or“ ▼”button to select a desired room temperature. (16℃-31℃)
- Press the “Fan Speed” button to select wind speed.
3. Dehumidifying operation
Press the “Mode” button till the “Dehumidify” icon appears .
- Automatically set the selected temperature to current room temperature minus 2
℃
.
- Automatically set the fan motor to LOW wind speed.
4. Fan operation
- Press the “Mode” button till the “Fan” icon appears.
- Press the “Fan Speed” button to select wind speed.
5. Heating operation (this function is not available for a cold-single unit)
- Press the “Mode” button till the “Heat” icon appears.
- Press the “▲”or“ ▼” button to select a desired room temperature. (16℃-31℃)
- Press the “Fan Speed” button to select wind speed.
6. Timer operation
Timer ON setting:
- When the air-conditioner is OFF, press the “Timer” button and select a desired ON time through the
temperature and time setting buttons.
- “Preset ON Time” is displayed on the operation panel.
- ON time can be regulated at any time in 0-24 hours.
Timer OFF setting
- When the air-conditioner ON, press “Timer” button and select a desired OFF time through the
temperature and time setting buttons.
- “Preset OFF Time” is displayed on the operation panel.
- OFF time can be regulated at any time in 0-24 hours.
7. Water Drainage
Water Full Alarm Function
The inner water tray in the air-conditioner has one water level safety switches, it controls the
water level. When water level reaches an anticipated height, the water full indicator lights up.
When the water is full, please remove the rubber blockage from the drainage hole at the bottom
of unit, and drain all water outside.
Maximum heating
Minimum heating
DB/WB(℃)
27/---
7/---