Awesomatix A12 User Manual

INSTRUCTION MANUAL
A12
1/12-SCALE ELECTRIC ON-ROAD CAR

Awesomatix A12 Specifications

General

Brand	Awesomatix
Model	A12
Category	Motorized Toy Car
Language	English

Summary

Awesomatix A12 Manual Introduction

Pre-Assembly, Safety, and Recommendations

Covers pre-assembly requirements, general safety precautions, and lists of recommended equipment/tools.

Step 4: Ball Joint and Spacer Installation

Front and Rear Ball Joint Assembly

Assemble front and rear ball joints with ST1205, ST1209L, OR125, and SH1.5W.

Step 5: Damper Rotor Preparation

Lubricating and Installing OR153V O-ring

Lubricate and install OR153V o-ring onto ST1202 damper rotor carefully.

Step 6: Damper Case Oil Filling

Filling ST1204 Damper Case with Oil

Fill ST1204 damper case with silicone oil and allow it to settle.

Step 7: Damper Assembly and Air Bleeding

Inserting Rotor and Bleeding Damper Air

Seat ST1202 rotor into ST1204 case and bleed air for proper sealing.

Step 8: Mirror Damper Assembly

Repeating Damper Assembly Process

Repeat steps 5-7 for the other side of ST1204 and ensure rotors are flush.

Step 9: Rear Downstop Adjustment

Setting Rear Downstop Screw SS3X10

Step 11: Front Suspension Attachment

Mounting Front Bulkheads to Chassis

Step 12: Wheelbase and Ride Height Adjustment

Setting Rear Ride Height with Shims

Step 13: Rear Beam Bearing Installation

Preparing and Pressing B168ZZ Bearings

Step 14: Steering Block Post Installation

Attaching ST1208 Steering Block Posts

Install ST1208 steering block posts using SB3X5 and SB3X6 screws.

Step 15: Steering Block Damping Setup

Adjusting Steering Block Damping Fluid

Adjust steering block damping via o-rings, shims, lubricant, and fluid viscosity.

Step 16: Front Spring and Preload Setup

Setting Front Spring Preload with Shims

Step 17: Servo Installation Procedures

Installing SANWA SRG and Mini Servos

Step 19: Steering Linkage Assembly

Connecting Steering Links P13-4/P1213

Step 23: Spur Gear Mounting

Installing Spur Gear AT1215 with O-rings

Step 24: Axle and Wheel Hub Assembly

Balancing Left and Right Wheel Hubs

Step 25: Pinion Gear and Drive Train Setup

Setting Pinion Gear Mesh and Tooth Count

Step 26: Wheel Mounting

Attaching Front and Rear Wheels

Rear Damper Ride Height (DRH) Setting

Adjusting DRH with Springs and Side Beams

Set DRH using side springs and AM1205 side beams/set screws for spring rate adjustment.

Rear Suspension Droop Setting

Measuring and Setting Droop Screw Depth

Measure and set rear droop using SS3X10 screw depth, enter value into setup sheet.