AWS AERO-100 - Scale Operation Steps; Powering On and Zeroing; Weighing Process

AERO Manual
III. Battery Installation
Low batteries can cause inaccuracies in digital scales. If
youareexperiencingissueswithyourscale,rsttrynew
batteries. Most times, this will solve the problem.
1. Beforeusingthescaleforthersttime,check
the battery compartment and remove any plastic
insulation strips or packaging that may be in place to
prevent battery drainage during shipping/storage.
2. If you are replacing the batteries, make sure the
positive and negative contacts are properly aligned.
IV. Operation
1. Placethescaleonaat,levelsurfaceandpressthe
key to turn the scale on.
2. Once the start-up process completes and the scale
goes to zero you are ready to weigh.
3. Place the quantity to be weighed onto the weighing
platform.
4. Wait a couple seconds for the display to stabilize
before taking a weight reading.
5. To turn the scale OFF, press the key again.
V. Changing the Unit of Measure
1. Press the M key to change the scales displayed unit
of measure.
2. If the scale is turned off then back on, it will default
to the last unit used.
• AERO-100 & AERO-650 Units: g (gram) oz
(ounce) ozt (troy ounce) dwt (pennyweight) ct
(carat) gn (grain)