( 9 ) Press <GREEN> button to enter Manual Scan Page.
(10) Press <Up/Down> button to select Frequency option.
(11) Press <0~9> button to input the Frequency value.
(12) Press <Up/Down> button to select Bandwidth option.
(13) Press <Left/Right> button to set Bandwidth value.
(14) Press <OK/Exit> button to start scan or exit. See Figure 2.
2.Menu Operations
Once the channel scan is finished and all the channels are stored into the
database,
you can start to watch the digital terrestrial TV channel or listen to the radio
broadcast, some typical operations are given in this chapter.
2.1 Main Menu
Main Menu for operating a lot of functions.
(1) Press <Menu> button to enter Main Menu.
(2) Press <Info> button to display the version information of STB.
2.2 SETUP
Set the system settings of STB.
2.2.1 Installation
Set the receiving and playing program settings of STB.
2.2.1.1 Antenna Setting
Set the antenna power on or off to supply +5V power to antenna or not.
Note: The default is OFF, set this option to ON only if this STB is connected
to an active antenna which amplifies the received RF signal, otherwise please set
it to OFF .
2.2.1.2 Country Setting
Set the country for Auto Scan, Manual Scan and Time Zone.
Note: Change the Country Setting will automatically change the default Time
Zone and set the default Frequency and Bandwidth for Auto Scan.
6
Figure 2. Manual Scan edit
MANUAL SCAN
01/01/2008 02:19
Channel No.
Frequency
CH .21
474.000 Mhz
Move
Move
Exit
Edit
Bandwidth
8 Hz
Scan
OK
65 %
94 %
Strength
Quality
To Next Page
Loading...