Axis 200+ - Page 15

Section 2: Installing the AXIS 200+ AXIS 200+ Users Manual
14
RS232 Serial
Connector
A 9 pin D-sub connector provides the physical RS232 serial interface
to a modem server within the AXIS 200+. This connector is discussed
in detail in Appendix E - The RS232 Serial Port.
Ethernet 10BaseT
Connector
10BaseT (RJ-45) twisted pair Ethernet connector for connection to
the network.
Power Supply
Connector
Jack socket for connection of AXIS 200+ power supply.
Caution!
The power supply delivered with your AXIS 200+ is country specific.
Please check that the type of power supply you are using is correct
against the checklist.
Indicators
Snapshot Indicator
The Snapshot indicator will flash on every occasion the AXIS 200+
takes a snapshot.
Power Indicator
The Power indicator is normally lit while power is applied. If it is not
lit, or it flashes, there is problem with the AXIS 200+ power supply.
Net Indicator
The Net indicator flashes to indicate network activity.
Camera Lens
Wide angle lens with rotational-focus control. Refer to Appendix C -
Technical Specifications for complete specification. Possible to mount
standard C/CS lenses. See Stage 8. Replacing the Lens, on page 19.
Serial Number
The serial number is located on the underside label of the AXIS 200+.
Please note that the serial number of your AXIS 200+ is identical to
the Ethernet address of the unit.