Step 1: On the "Motor" page, change the default QUAD X to OCTO X8, and then click Save and restart.
Step 2: After step 1 is completed, eight motors will appear on the right side of the motor page. Please adjust and verify the
rotation direction of the eight motors according to the arrow on the left schematic diagram. The actual rotation direction and
definition of the motor must be consistent with the left schematic diagram. All propellers must be removed before connecting the
battery!
Step 3: Read carefully and tick "I have understood the risk", slowly push the main control to about 1100, observe the motor
rotation direction, if it is found that it is inconsistent with the schematic diagram on the left, click "Motor dlrectlon" to adjust
according to the wizard, if it is found that the motor sequence is inconsistent with the schematic diagram, click "Reorder motors"
to adjust according to the wizard, and click Save and Restart after each adjustment.
5.Steps for X8 FC parameter setting
To Next Page
Loading...
