Need help?Do you have a question about the Axis A1610 and is the answer not in the manual?
General| Enclosure | Plastic |
|---|---|
| Audio Output | 1 x 3.5 mm mini-jack |
| Protocols | ONVIF |
| Memory | 512 MB RAM |
| Network Interfaces | 1 x RJ-45 10/100 Mbps Ethernet |
| Mounting | Wall |
| Compliance | EN 55032 Class B, EN 61000-3-2, EN 61000-3-3, EN 55024, EN 61000-6-1, EN 61000-6-2, FCC Part 15 Subpart B Class B, ICES-003 Class B, VCCI Class B |
Introduction to the AXIS A1610 Network Door Controller and its installation guide.
Contains liability, intellectual property, equipment modification, and trademark information.
Details EMC and Low Voltage Directive compliance for Europe.
Information on FCC rules and compliance for the USA.
Information on product safety, disposal, and recycling regulations.
Provides contact information and resources for product support and warranty.
Outlines UL 294 compliance requirements and safety instructions for installation.
Specifies performance levels for access control as per UL 294 standards.
Lists readers verified by UL for compatibility with UL 294.
Details the operating temperature and humidity ranges for the device.
Specifies wiring types, gauges, and connector requirements for the product.
Outlines requirements for various cable types and their specifications.
Specifies qualified lengths and cable types for reader data and powered controllers.
Defines hazard levels (DANGER, WARNING, CAUTION, NOTICE) and message levels (Important, Note).
Provides essential safety guidelines for installing and using the Axis product.
Lists the physical components and accessories provided with the product.
Step-by-step guide to opening the AXIS A1610 unit.
Instructions on how to access the internal parts after opening the unit.
Instructions for installing the mounting bracket for the AXIS A1610.
Detailed steps for physically mounting the AXIS A1610.
Guide for attaching the mounting plate to the unit.
Steps for making the first wire connections to the unit.
Guidance on managing cables during the installation process.
Steps for preparing wire ends to ensure secure connection to terminals.
Instructions for closing the AXIS A1610 unit after wiring.
Final steps to secure the AXIS A1610 unit in its installed position.
To Next Page
