Axis AX1200 - Operating Instructions: Basic Functions; Power, Mute, Select, Volume Controls; Advanced Settings: Clock, Display, Audio Modes; Radio Preset Station Management

5
OPERATING INSTRUCTIONS
1. POWER ON/OFF
Press any key to power the unit. Press and hold to turn off.
2. SELECT
3. VOLUME UP/DOWN
7XUQLQJWKH92/NQREWRULJKWRUOHIWWRFRQWUROWKH92/80(7RVHOHFWRWKHUIXQFWLRQVKROG
the VOL knob down until the desired functions is shown on the display. Figure 1 shows how
control functions are selected using the VOL knob.
1 2 3 4 5
SEL SEL SEL SEL SEL
Fig. 1 Selection of sound control functions
1. VOLUME 2. BASS 3. TREBLE 4. BALANCE 5. FADER
 7KHVHEXWWRQVFDQEHXVHGWRDGMXVWWKH%$6675(%/(%$/$1&(DQG)$'(5
Press and hold VOLNQREWRDGMXVWEHORZIXQFWLRQ
I-VOL
SEL
2 sec.
SEL
ADJ CLOCK
SEL
DISP
SEL
STEREO
SEL
LOC OFF
SEL
EQ OFF
I-VOL
 7XUQWKH92/NQREWRVHWWKHYROXPHOHYHOZLWKZKLFKWKHGHYLFHLVWREHVHWZKHQWXUQHGRQ
ADJUST CLOCK
Turn VOL knob to right for hours and left for minutes.
DISPLAY
Time displayV
STEREO/MONO
:KHQ)0VLJQDOLVZHDNRUGLVWRUWHGUHFHSWLRQPD\LPSURYHE\WXUQ92/NQREWRVHOHFW0212
LOCAL
“Local” position in areas with strong signal will cause radio to only WXQHstrong stations. During
manual tuning (LOC appears). Select Distant position in areas with weak signal. Turn the “VOL”
knob to set the LOCAL ON/OFF.
EQ MODE
Turn VOL knob to select one of the settings EQ OFF/CLASS/ROCK/POP/EQ FLAT.
4. PRESET STATIONS (1,2,3,4,5,6)
(A) RADIO MODE:
Six numbered preset buttons store and recall stations for each band.
Storing a station:
1. Select a band (if needed)
2. Select a station
3. Hold a preset button longer than one second. Preset numbers appear RQ the display when station
is saved.
MUTE
Press WKLVEXWWRQEULHIO\WRVHOHFW087(7RUHVWRUHVRXQGSUHVVDJDLQ