EasyManuals Logo

Axis M1033-W Installation Guide

Axis M1033-W
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be deter-
mined by turning the equipment o and on, the
user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment •
and receiver.
Connect the equipment into an outlet on a •
circuit dierent from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV •
technician for help.
The product shall be connected using a shielded
network cable (STP) that is properly grounded.
Canada
This digital apparatus complies with CAN ICES-3
(Class B). The product shall be connected using
a shielded network cable (STP) that is properly
grounded.
Cet appareil numérique est conforme à la norme
CAN NMB-3 (classe B). Le produit doit être con-
necté à l’aide d’un câble réseau blindé (STP) qui
est correctement mis à la terre.
Europe
This digital equipment fullls the requirements
for RF emission according to the Class B limit of
EN 55022. The product shall be connected using
a shielded network cable (STP) that is properly
grounded. This product fullls the require-
ments for immunity according to EN 61000-6-1
residential, commercial and light-industrial
environments. This product fullls the require-
ments for immunity according to EN 61000-6-2
industrial environments. This product fullls
the requirements for immunity according to EN
55024 oce and commercial environments
Australia
This digital equipment fullls the requirements
for RF emission according to the Class B limit of
AS/NZS CISPR 22. The product shall be connected
using a shielded network cable (STP) that is
properly grounded.
Japan
の装置は、スB 情報技術装置ですの装置は、
家 庭環境で使用すを目すが、
装置が ジオレビン受信機に近接て使用
受 信障害を引きがあます取扱説
明書に従い取扱い下さい。本製品は、
ールドネケーブル(STP)を使用接続
い。た 適切に接地ださい。
Korea
이 기기는 가정용(B급) 전자파적합기기로서 주로
가정에 서 사용하는 것을 목적으로 하며, 모든 지
역에서 사용할 수 있습니다. 적절히 접지된 STP
(shielded twisted pair) 케이 블을 사용하여 제품을
연결 하십시오.
Radio Transmission
This equipment may generate or use radio fre-
quency energy. The user could lose the authority
to operate this equipment if an unauthorized
change or modication is made.
USA
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesirable operation.
This product complies with FCC radiation
exposure limits for an uncontrolled environment.
Avoid operating this product at a distance less
than 20 cm (7.9 in) from the user.
Canada
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
This product complies with IC radiation exposure
limits for an uncontrolled environment. Avoid
operating this product at a distance less than 20
cm (7.9 in) from the user.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter
tout rouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le
fonctionnement.
Ce produit est conforme aux limites d’exposition
aux radiations IC pour un environnement non
contrôlé. Évitez d’utiliser ce produit à une dis-
tance inférieure à 20 cm (7,9 po) de l’utilisateur.
Brazil
Este produto está homologado pela ANATEL, de
acordo com os procedimentos regulamentados
pela Resolução 242/2000 e atende aos requisitos
técnicos aplicados.
Este equipamento opera em caráter secundário,
isto é, não tem direito proteção contra interfer-
ência prejudicial, mesmo de estações do mesmo
tipo, e não pode causar interferência a sistemas
operando em caráter primário.
Para maiores informações, consulte o site da

Other manuals for Axis M1033-W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Axis M1033-W and is the answer not in the manual?

Axis M1033-W Specifications

General IconGeneral
BrandAxis
ModelM1033-W
CategorySecurity Camera
LanguageEnglish

Related product manuals