Axis P1353–E Configuration Guide

Configuration guide  Mechanical PTZ configuration on the AXIS P135X cameras
Rev: 1.1, Last updated: 02/04/2013 1
Configuration guide
Mechanical PTZ configuration on
the AXIS P135X cameras
This document shows how to configure AXIS P135X cameras to control primarily
a PT head and optionally a zoom lens.
1 Configuration steps
Follow the below configuration steps after connecting the PT head to RS-485/RS-422 serial port
of the camera. Connection schemes are available for particular PT head on driver support pages.
General pin assignment is as follows:
Function
Pin
Notes
RS-485/RS-422 Tx (A)
1 (Tx+)
Tx pair for RS422 and 4-wire
RS-485
RS-485/RS-422 Tx (B)
2 (Tx-)
RS-485A alt. RS-485/RS-422
Rx (A)
3 (Rx+/Tx+ alt Rx+).
Rx pair for all modes
(combined Rx/Tx for 2-wire
RS-485)
RS-485B alt. RS-485/RS-422
Rx (B)
4 (Rx-/Tx- alt. Rx-)

Axis P1353–E Specifications

General

Frame Rate	30 fps
Image Sensor Size	1/3"
Day/Night	Yes
Aperture	F2.0
Minimum Illumination	0.5 Lux
Compression	H.264, Motion JPEG
Ethernet	10Base-T/100Base-TX
Power over Ethernet (PoE)	IEEE 802.3af
Ingress Protection	IP66
Vandal Resistance	IK10
Digital Zoom	Yes
Resolution	1280x960
Focal Length	2.8 mm
Protocols	HTTP, HTTPS, TCP, UDP, IPv4/v6, ICMP, IGMP, RTSP, RTP, RTCP, FTP, SMTP, ARP, DHCP, NTP, DNS