Axis P3727-PLE Repainting Instructions

AXISP3727-PLENetworkCamera
Repainttheproduct
Repainttheproduct
Preparations
•Ifapplicable,disassemblethedeviceaccordingtotheinstructionsinthisdocument.
•Cleanallpartstoberepaintedthoroughlytoremovegrease,dust,oroil.
•Toensurereassemblyandfunctionalityoftheproduct,maskanyopenings(forexampleforscrews,LEDindicators,
ormicrophones)beforeyoupaint.
Pretreatmentofparts
Dependingonthepartmaterialandtypeofpaintappliedatfactory,differentpretreatmentshouldbedoneforthenewpaintto
adhereaswellaspossible.Cleanthepartsproperlytoremoveoil,greaseanddust.
Formoreinformationonthematerialsusedintheproduct,seeitsdatasheetataxis.com.
Powdercoatedparts-Useaprimer.Alternatively,removetheoriginalpowdercoatingdowntothebasematerial,usingne
sandpaper,andcleanthepartsbeforepainting.
Anodisedandchromatedparts-Useaprimer.
Uncoatedstainlesssteel-Nospecialpretreatmentisneeded,butmakesurethatthesurfaceiscleanbeforepainting.
Plastic-Useaprimer.
Disassembly
TR20
4x
1.Removethescrews.
2.Removethedomecover.
3

Axis P3727-PLE Specifications

General

Number of Sensors	4
IR Illumination	Yes
Day/Night Functionality	Yes
Weather Resistance	Yes
Vandal Resistance	IK10
Power over Ethernet (PoE)	Yes
Maximum Resolution	1920x1080
WDR	Yes
Audio	Yes
Operating Temperature	-40 °C to 60 °C (-40 °F to 140 °F)
Ingress Protection	IP66
Sensor Type	CMOS
Aperture	F1.6
Ethernet	10/100 Mbps
Lens	Varifocal
Video Compression	H.264, H.265, MJPEG
Frame Rate	30 fps
Edge Storage	Yes
Power	PoE
Lens Type	Varifocal
Operating Conditions	-40 °C to 60 °C (-40 °F to 140 °F)
Image Sensor	CMOS