Axis
Owners
Manual
2019
Page 151
The boat has been constructed with various metal components, all of which require special
attention during routine care. Decomposition occurs, resulting in rust, and it is
accelerated when the boat is operated in salt water.
Damage that occurs to the boat as result of corrosion is not
covered under the warranty!
While Axis uses quality metal components chosen for their durability as well as
attractive appearance, all metal eventually reacts to exposure to water. Therefore, part
of the care and maintenance of metal requirement is to ensure that it is kept clean and
dry. After an outing, rinse the metal pieces as well as the rest of the boat, allowing, at
minimum, a thorough air drying. To avoid spotting and discoloring, drying with a soft rag
or towel will keep the new-boat look for many seasons to come. It is also wise to wash
all metal components when you wash your boat as this will help prevent moisture from
aecting the surface.
When boating in brackish or salt water, the post-outing cleaning is highly critical for the protection of
the nishes. Corrosion potential means that boats operating in this type of condition must be equipped
with self-sacricing zinc anodes. These anodes are attached in several locations, including the transom,
driveshaft and rudder. (Check with your authorized Axis dealer to be certain that you are aware of all
locations of these anodes as they will require periodic replacement.) The anodes serve to signicantly
reduce the potential for corrosive damage to the permanent metal components on the boat.
Boats operated routinely in salt water should also be equipped with a closed cooling system
to protect and extend the life of the engine. See the engine owner’s manual for more information
regarding this important topic.
If the boat owner begins to notice rust or deterioration of metal components, even when operated
regularly in fresh water, this should be brought to the attention of the authorized Axis dealer. In some
instances, it is necessary to attach self-sacricing zinc anodes, even when operated in fresh water. Be
safe, rather than sorry!
Protection: Axis has determined that the use of Corrosion Block is necessary to ensure long
life for metal components. The use of Corrosion Block, available at www.corrosionblock.com,
as directed on the bottle or can is required to keep the warranty in force. Corrosion Block comes
in aerosol spray, liquid that can be placed in your own spray bottle, or as a grease. Avoid getting
Corrosion Block on other, non-metal surfaces. If this occurs, clean as directed by the product’s
directions to avoid stains that are also not covered under warranty.
Among the metal components that should be routinely and regularly treated with Corrosion Block are:
• any metal seacocks or ball valves • hinges
• any stainless steel or aluminum screws • power terminals
• Auto-Set Wedge/Surf Gate actuators • engine mounts
• stainless steel hose clamps • alternator
• transmission coupler • board rack pivots
• gas shocks • board rack moving parts
• tower stainless steel inserts • buss bars
• power terminals • helm seat slides
• starter • trailer tongue assembly
• Bimini metal moving parts • trailer swing tongue pin
• under side of trailer
Failure to use Corrosion Block as directed on the product label will result
in the nullication of the Axis warranty in instances of corrosion damage.
Failure to clean Corrosion Block o non-metal surfaces can result in damage
that is not covered under warranty.
Axis uses only marine-rated and marine-grade fasteners on all models. If,
at any time, it is necessary to replace any fasteners, seek guidance from
an authorized Axis dealer to ensure that such replacements meet the
requirements for operation in a marine environment.
stainless steel,
chrome and
aluminum
components
To Next Page
Loading...
Need help?
General
