anchoring point needs to be as close to the oor
as possible. In doing so you you should always
insert the buckle through the closest appropri-
ate slot in the strap tp create a slip knot then pull
tight. is needs to be repeated on both sides to
create two anchor points. When installing Du-
ox in the front passenger seat the tether straps
must be attached to the front gliding tracks so
the tether points will be located along the front
edge of the passenger seat.
Pull out the upper anchorage strap from the
belt housing (5) to an appropriate length.
Check that the white marking on the strap
(6) is visible. If not, you can try crossing the
straps over to give them some extra length to
enable the white marking to be visible. Clip
the anchor attachment directly onto the an-
chorage point. Repeat on the other side. Press
down hard on the on the red mark(7) on the
top right side of the child restraint then re-
peat for the left side(7). When you do this its
important that you really use your full body
weight to press down and get the tether straps
to really tighten hard. is will give the an-
chorage straps their rst tightening.
Unfold the support leg out to its maximum
angle. Pull out the top latch to release the up-
per part of the support leg (8) until it reaches
the oor. If the support leg does not reach the
oor, repeat with the lower latch(9). Its impor-
tant that you check that the support leg is an
angle over 80 degress from the back of the
seat. You could check this by ensuring that
the support leg is further away from the seat
then the vertical line(10).
Press down on the child restraint from
side to side again, the anchorage straps will
be then be automatically tightened.
13
Continued on next page
5
8
9
6
11
10
7
To Next Page
Loading...
