WHITE
AXMINSTER
W
12
Assembly...
FREEPHONE 0800 371822
Fig 23
Fig 24
Slide cast iron disc (G) onto the drive shaft, making sure that the clamping screw lines up
with the hole pre-drilled at the top guard moulding (F). Slide a phillips screwdriver down the
hole and tighten the screw, clamping the disc to the shaft (See figs 23,24 & 25).
G
F
Fig 25
Fig 26
Pre-drilled hole
Slide a phillips
screwdriver
down the hole
& tighten the
screw to clamp
the disc.
Locate the dust extraction moulding (C), line up the pre-drilled holes with the holes in the
guard moulding (F), push the extraction moulding (C) up against the guard moulding (F),
so it clips to the guard. Put to hand the two M5 x 8mm phillips screws, finger tighten lightly
into the holes & using a phillips screwdriver tighten the screws. DO NOT OVER TIGHTEN
(See figs 26,27 & 28)
Phillips screw
Fig 27
Fig 28
C
C
F
To Next Page
Loading...
